Batteries/Chargers/Distribution/Sensors (190)

Discussions Replies Latest Activity

X6 new build battery discharge question

This is a new problem for me but I am sure the answer lies in the physics of batteries and that one of you can explain it to me. I have a n…

Started by Bob Smith

2 16 minutes ago
Reply by Bob Smith

On what web pages can I buy Li-Ion batteries?

Hi, could you tell me where to buy Li-Ion batteries safely and, preferably, can ship to Peru? Thank you.

Started by Oscar Renato

3 Nov 2
Reply by Justin Baxter

What happens if use Li-Po battery at max c-rating???

Hi there,   I was wondering what would happen if we operate the Li-Po battery at max c-rating? I was operating a quad-plane VTOL in RTL mod…

Started by Kane

0 Oct 31

Safety First: 100A & 200A Hall Sensor with BEC for Pixhawk / APM

After I had a few problems with the standard power module from 3DR and the ones from Hobbyking, like falling off resistors (overheated) and…

Started by Christian Mauch

105 Oct 12
Reply by Nathaniel McMahon

Sonar sensor with pixhawk

I have been trying interfacing the MB1242 Sonar sensor with pixhawk as this link explained below http://ardupilot.org/copter/docs/common-ra

Started by Baskaran K

0 Aug 1

daisy chained PX4FLOWs for precision positioning

Hi everyone, I’m new here. The PX4FLOW manual seems to suggest that two sensors can be daisy chained together. Has anyone tried this? Ultim…

Started by Christian Boutan

0 Jul 12

Powering companion computer from same battery as motors.

So I am working on developing a companion computer platform (used for vision based navigation and obstacle avoidance in indoor/outdoor envi…

Started by Ryan

5 Jun 28
Reply by Fnoop

DS18B20 Temperature sensor not recognized

Hi Gurus, I'm trying to hook up a ds18b20 temperature sensor (in fact a breakout board like this) to a old RPi (ver 1) model B, running Die…

Started by yamadanao

0 Jun 23

Airspeed Sensor

Is the airspeed sensor required on when setting up a pixhawk mini on a fixed wing?

Started by Matthew S Dreyer

1 Jun 21
Reply by Matthew S Dreyer

Battery voltage failsafe

Dear all, I am using a Tiger battery 4S 6000mAh 35C and I set the voltage failsafe in Mission Planner at 14.0V (3.5V per cell as suggested…

Started by Mattia

5 Jun 21
Reply by christopher.shiny

RSS

© 2017   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service