Flying/Tuning Mulitcopters (298)

Discussions Replies Latest Activity

Tricopter yaw issue

So I'm having some problems setting up my tricopter. When I increase the throttle the yaw is also affected. The back motor begins to turn l…

Started by Tegan Burns

2 10 hours ago
Reply by Gary Mortimer

Question regarding flight controls changing during flight

This is my 250 size micro quad running KK2.1.5, 800mah 3 cell lipo. The trim starts out good and as I fly it slowly begins to change, event…

Started by Tim Pritts

0 23 hours ago

Vibration Isolation and Dampening of APM / PX4 for version 2.9

Now that we have version 2.9 and inertial primary control for the Z axis and soon to have it for X and Y axes as well it is necessary to ta…

Started by Gary McCray

410 yesterday
Reply by Forrest Frantz

Calibrating Transmitter hk-t6a v2, setting endpoints, trimming etc.

Hello All,So I have been wracking my brain for a couple of weeks and I have done a lot of research to try to fix my problem of my motors ru…

Started by pantera1025

0 Nov 16

Unable to stop props/disarm Iris+ quadcopter as soon as on ground

I have lost multiple props on Iris+ due to inability  to immediately stop props when it  on ground or is thrashing brush after a minor wrec…

Started by Nikon Photog

0 Nov 16

3DR RTF Y6 jumping around in all flight modes possibly after using a DIY camera mount

I've been using a 3DR RTF Y6b with Pixhawk since early summer with no problems.  I never play with parameters.  I normally would fly with t…

Started by Morgan Matelski

0 Nov 12

Work opportunities

Hi  I am looking for pilots with the following certification AVI30813 - Certificate III in Aviation (Remote Pilot - Visual Line of Sight --…

Started by Jairo Campos

0 Nov 3

Low RPM Heavy Platform AutoTune

Perhaps one of the developers could chime in here. I have a question as to whether AutoTune will work well with a platform that weighs almo…

Started by Oliver Volkmann

2 Oct 30
Reply by Oliver Volkmann

Getting the PIDS right on a heavy copter

My Initial Factory settings:     I recently finished and assembling a QAV540G Quad with low KV high wattage motors with a 6S 5100 Battery…

Started by Richard Evans

11 Oct 22
Reply by Scott Penrose

New to this forum. Qu4d Question.

I am wanting to know if by moving my front arms forward and the back arms closer would I bennifet from making it into a X shape at all... I…

Started by Jonathon R

2 Oct 16
Reply by Jonathon R

RSS

© 2014   Created by Chris Anderson.

Badges  |  Report an Issue  |  Terms of Service