All Discussions Tagged 'engine' (19)

Discussions Replies Latest Activity

DIY ESC/engine/propeller tester

Hi, I made engine tester based on arduino. I would like to ask you, if someone/something does exists ? I found only too expensive commercia…

Started by Ivosch

14 Nov 24, 2016
Reply by Ivosch

6-7 Hour Flight time over ocean - some questions

Hey everyone!  I'm new here but I've been reading/researching around this site and its forums for weeks.  I've learned a lot and tried to r…

Started by Dronez

30 Nov 1, 2016
Reply by David L.

State of the Art Novel InFlowTech 1Gearturbine RotaryTurbo 2Imploturbocompressor One Compression Step

 State of the Art - Novel InFlow Tech - Featured Project Development; 1-Gearturbine, 2-Imploturbocompressor: *Wordpress Blog State of the…

Started by Carlos Barrera

0 Sep 27, 2016

L3 Thermal-EYE FLIR Thermal Imager Core Infrared Camera Engine $255

We have some left over thermal imager cores. These are the internal infrared camera engines that are in finished products. We have it liste…

Started by Randall Kolchins

5 Sep 20, 2016
Reply by Florin Petrutiu

Long range UAV (at least 40 miles?)

Any ideas for an air frame, engine, electronics,  payloads.

Started by Nathan Keil

2 Sep 8, 2016
Reply by summer Brings

Activate PreFlare to 70meter, before the last waypoint on final approach.

DearI want to know how I can modify the code autopilot to modify the code reverse motor before the last waypoint in approach and not the la…

Started by Daniel Sanguinetti

0 Jun 3, 2016

Throttle Servo lock out in a gasoline engine with pixhawk

Hi all, My setup is as follows: Pixhawk running Arduplane 3.2, RFD 900, Futaba s3005 servos on all surfaces including throttle, Gasoline en…

Started by Karthik

0 Feb 10, 2016

Possible Motors to lift 7kg Octo Hybrid

Hi, I have built a prototype octocopter with a large central prop (19x10) powered by a 35cc engine (so technically a nonacopter?). The eng…

Started by Lucy Ruck

0 Feb 4, 2016

3D-Printed Motor Pod

Here is a couple of motor pods that I 3D-printed. Mesh type (biomimicry/biostructure) pod is much lighter but still feels quite strong...th…

Started by Veikko Vierola

0 Feb 3, 2016

1945 Kiekhaefer 0-45-1 runs

I just completed my 1945 Kiekhaefer 0-45-1 engine (747 cc, 20-22 hp, 35 lbs) restoration to ground running status only. It was used in the…

Started by Tom Fey

0 Sep 15, 2015

RSS

© 2017   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service