Sort by:
| Discussions | Replies | Latest Activity |
|---|---|---|
Multicopter not lifting too heavy, time to upgrade parts!(AERIAL VIDEO PRODUCTIONS) For heavy lifting, on the low budget. What is the best way to upgrade this? Specs: apm 2.5 control board APC 1… Started by andrew |
6 |
yesterday Reply by andrew |
Looking for low latency HD IP based cameras, prefer ethernet connectionI'm looking for low latency 1080p cameras that stream, and can be used with VLC but with a physical ethernet connection (and small enough t… Started by James Small |
0 | Jun 10 |
Power module gives 0.4V to APMI recently bought a new Arducopter Hexa from 3DRobotics. I was able to fly 3 times (each about flight only about 5 minutes) and now for no… Started by Alexander Landmesser |
6 |
May 10 Reply by Alexander Landmesser |
3DR Power Module AccuracyHow accurate is the 3DR power Module? We set our Mission Planner warning to go off at 13.5 v on a 4s 8000mah battery. We had only used 25… Started by Matt |
4 |
Feb 27 Reply by Brenton Lohrisch |
Why are motors not getting full power from arducopterArducopter is limiting the total power output of my hexacopter to 37 amps when it has the potential for 66amps when at full throttle. I ben… Started by Larry Grimm |
12 |
Jan 25 Reply by Criterion-Industries |
Programming ESC's as nicads even though they are lipo'sI read someone is programming their ESC's as if they were nicads even though they are running lipo's. Apparently the idea is when one do… Started by Rick Eis |
1 |
Sep 3, 2012 Reply by Mike Boland |
Aerial Photography on the Cheap..Seems the market is opening up to DIY hobbyists wanting to do their own aerial photography shots. $500 for a nice looking basic hex-copter… Started by Mark Massel |
0 | Aug 16, 2012 |
Season Two of the Trust Time Trial (T3) Contest has now begun. The fourth round is an accuracy round for multicopters, which requires contestants to fly a cube. The deadline is April 14th.203 members
24 members
207 members
58 members
1355 members
© 2013 Created by Chris Anderson.
Powered by
