All Discussions Tagged 'outputs' (6)

Discussions Replies Latest Activity

APM2 repair options (fried APM2 board)

hey did you guys hear the joke about the 3DRobotics APM2 repair paths?   oh wait there are none! Beware folks don't fry your APM2... it…

Started by CensoredUser ExWikiNinja aka KF

19 Sep 24, 2013
Reply by Willem

Output A08 Freaking Out Savox Servo on AV200 Gimbal

Hello, I'm having a hard time getting output 8 on my APM 2.5 to control any of the three Savox servos on an AV200 gimbal. The servos freako…

Started by Julio Alvarez

5 Apr 13, 2013
Reply by Duffy

APM_radio_test.pde not outputting PWM values properly

Can't seem to get the APM_radio_test to do what I think it should do (output pwm values from the receiver)...I'm using APM2.0, Arduino IDE…

Started by David Hertzog

0 Oct 19, 2012

Xplane 10 sim and APM planner issues

Hi guys We are desperately looking for assistance with a few issues we have currently with getting our ardupilot setup to function correctl…

Started by RhinoUAV

1 Aug 20, 2012
Reply by Paul Marsh

Outputting high and low signals on the servo outputs

I am rewriting the void loop() function in arduplane to use it as a system to control airbrakes on a rocket. I want to be able to control a…

Started by Beau Willar

0 Apr 11, 2012

PWM output on 2.0.42

Hi, I measured a PWM output on sparkfun ATmega1280 and I found that when system is not armed all pwm outputs are 50 Hz, 1 ms, when I arm t…

Started by Angelo Rossi

7 Oct 10, 2011
Reply by Edwin Hayes

RSS

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Drone Delivery Challenge, is here

© 2014   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service