Discussions

Sorry for posting twice but I think my first post was in the wrong category.

I am trying to use my new DX8G2 with Mission Planner for my Octo. For those of you familiar with Mission Planner, it gets its flight modes from the Gear channel on the TX. I can get 4 flight modes but not 6.

Here is how I have it set up. First, TX is in multirotor mode instead of acro. Spektrum Flightmode switch is inh.

Gear Travel: D -70 U +68

Mix1: Gear >Gear; Rate D-38% U -42%; Switch A (Gear Switch; 2 position switch)

Mix2: Gear >Gear; Rate D-38% U -40%; Switch B (Gear Switch; 3 position switch)

So I get flight modes 1, 2, 4, and 5. when switched to 3 and 4 they go back to 1 and 6.

I can get 3 and 4 by adjusting the U on mix 2 but then I lose 2 and 4. I cannot seem to get the 3 position switch to give me 3 positions.

Does anyone know what I am doing wrong?

Thanks,

Clint