apm 1.0 flight data displayed disarmed

Guys i need help because of my apm 1.0 when i connect the apm to may computer it successfully connect but the flight data displayed disarmed and when i tilt the apm the screen did not respond anymore.. please someone tell me whats going on in my apm? is my apm already destroyed? thanks
------------

0 members like this

▶ Reply to This

Replies to This Discussion

Permalink Reply by Luke Olson on October 7, 2012 at 8:47pm

There might be a connection issue between the APM and the IMU shield. Check the pins with a meter to make sure they all have a good connection. Also try flashing the firmware and erasing the flash (see the wiki). If those don't get you anywhere the board might be toast. Did anything happen to it, too high of input voltage, dropped, get wet?

▶ Reply

RSS

Welcome to
DIY Drones

Sign Up
or Sign In

Or sign in with:

Social Networking

Top Content

1	APM 2.5 from hobbyking
2	Alt_hold and loiter acting crazy
3	Mapping Mission Ride Along
4	Looking for best laptop screen to see in the sun
5	APM Copter 2.9.1.b has been released
6	ArduPlane 2.73 released
7	New micro-cameras emulate insects' compound eyes
8	Hobby King Ardupilot
9	3 axis Camera Gimble connections.
10	Thirty Days (#17): 12-rotor close up

RSS
View All

Contests

Season Two of the Trust Time Trial (T3) Contest has now begun. The fourth round is an accuracy round for multicopters, which requires contestants to fly a cube. The deadline is April 14th.

A list of all T3 contests is here.