APM 1280 setting up problems...

Hello!

I have problem when i try to setting up my APM1280 with Mission Planner.

When i load the FW 2.0.55 Quad, everytihing seems ok. until i try to set up my radio.I have no respond from any radio channel, and i have no response from the flight data either.

When i connect to my APM in the terminal, i get signal from my radio.

I power my boards by a external battery connected to the rc-pins.

Thankful for any help i can get, Thanks!

/Mikael

0 members like this

▶ Reply to This

Replies to This Discussion

Permalink Reply by Tero Koivunen on December 14, 2011 at 1:50pm

Similar problems too, in CLI "terminal" everything works.

▶ Reply

Permalink Reply by Mikael Svensson on December 16, 2011 at 5:53am

Nobody has any idea?

/Micke

▶ Reply

RSS

Welcome to
DIY Drones

Sign Up
or Sign In

Or sign in with:

Social Networking

Top Content

1	APM Project vs DJI NAZA and WOOKONG
2	ArduCopter-3.0 ready for wider use
3	Flying 3D Spline Curves between Waypoints with ArduCopter 3.0
4	APM Copter 2.9.1.b has been released
5	APM 2.5 with NEO-6M ublox gps (not 3DR LEA-6)
6	10k autonomous flight - telemetry guided flight, and other APM tests!
7	MAAT final version is being tested
8	Getting ready for Arducopter 3.0
9	Help Tuning Arduplane 2.73 With A Large Slow Airframe
10	SolarSight, The University of Michigan SolarDrones UAV

RSS
View All

Contests

Season Two of the Trust Time Trial (T3) Contest has now begun. The fourth round is an accuracy round for multicopters, which requires contestants to fly a cube. The deadline is April 14th.

A list of all T3 contests is here.