That's the whole idea - to limit the data sent to the flight controller - with this config file, only the data which is needed is sent, which allows it to be sent at a higher rate.
We have this board but not the connectors - could some knid person please indicate exactly what connection cable is required to join the two
1. I was also looking for a cable connecting apm to gps and here's what I found:
2. Can anyone let me know if I can use USB ISP programmer or any Arduino to upload 3dr file into NEO-6M gps unit?
Yes I've seen that contact but fear that they on on holidays (virtually no stock).
Thank you Ralf
Does anybody know where to get a molex 1.25mm 4pin to 5pin connector that's not with unmannedtechshop
I just ordered one, we'll see how long it will take.
Another option is to get 4pin Molex male to male cable, then buy 5pin Molex connector and switch one side.
No, Scott. Changing and saving the settings doesnt help at all.
According to Michael Naumov, AC overwrites your changes anyways, until you change the code.
After that I tried to check my modified GPS receiver on APM2.5 by leaving my copter outdoor for about 10 minutes and to collect some statistics with shape of track on MP. And what I see: any modifications don't take effect on performance since you plug GPS receiver to APM.
That is the reason U-BLOX CN-06 V2 is running out of the box.
So it doesnt matter whatever the U-Center shows you...
just for your information.. move your ESCs away from APM and GPS as far as possible. So nearby your motors. That helped for me to get +1 Sat. Some ESCs harmonics influence GPS..
BTW to avoid APM is resetting GPS you must change the APM firmware. It's described in some very early posts of that discussion.