I have a suspected BEC blowout.
Fully charged configured and ready to fly. Replaced my servo (the one that went mental) and re-checked everything with debugs. I turn on and instead of the 3 chirps of startup I get nothing.
Of the 3A from the BEC APM with its bits eats up 750mA according to an earlier post so I have 2250mA for three servos and the receiver. The receiver is stated at being 80mA so lets say thats generous and take my reserve to 2000mA. Surely three servos are not drawing 2000mA.
Everything is installed by the manual and up to date. 0 compilation errors and passed all the debug checks. Only running hardware manual, stabilize and FBW_B.
Have I setup something in the config wrong maybe?
In the plane:
Replies are closed for this discussion.