Frequently asked questions are about powering an APM2.5 or why the same does not work or why it has failed.

Here is a simplified schematic showing the major components of the 5V/Vcc circuit on the APM2.5

Target Audience: Readers who do not have Eagle or are confused about using it.

You Need: Basic electronic schematic reading ability

Note that I have separated the PWM Output section into the upper left corner with a heavy purple line that is bridged by the jumper JP1 on the APM2.5. This is to emphasize that diode D1 passes current through JP1 (and drops voltage). The remaining energy is then called 'Vcc'.  Everything outside the purple corner is Vcc.

This is why the USB will power the APM2.5 when connected to a computer/USB hub. Note the fuse on the APM2.5 side of the USB connector AND another fuse on the output of D1. Another change from APM2.0 is the D4 6.0V Zener diode. If an over voltage is applied to the board, D4 will crowbar what it can to protect devices.

As with APM2.0, any 5V source connected to any of the indicated Vcc/5V points outside the purple corner (with GND of course) will power the APM2.5.

Also of note is the 'Mystery Port'. This port takes 5VDC before D1 and the fuse and is called 'JP_VCC'. Other clues to the mystery are the lines to 'ADC 12' and 'ADC 13'. A mystery indeed!

Any errors in this drawing from editing are mine.

I hope this can be used as reference for solving problems.



27-FEB-2014 Eagle files are now located HERE


Views: 58761


Reply to This

Replies to This Discussion

Dear Goud,Bill,

I have installed the BEC as we said according to the schematic of my previous post, and here are my findings..

When I connect APM to Mission Planner, my hwvoltage value is now almost steady playing between 4.90V and 4.94V. So everything good.. Before the BEC install the hwvoltage used to fluctuate between 4.45V and 4.81V..

However when I measure again with the voltmeter in the same points as I used to do before installing the BEC, you can see in the following pictures my new measured values...

SO it seems like the hwvoltage value has been fixed but the voltmeter values have been damaged...

Please give me your comments...

Thank you


© 2015   Created by Chris Anderson.

Badges  |  Report an Issue  |  Terms of Service