APM2 Solder points question
Hello all,
My APM2 arrived today and is now soldered together. I had just one question though.
There are 6 single pins that seem to come from the main board to the daughter board. Am i to solder the daughter board to the main board with these 6 single pins?
I found this picture which leads me to believe that I am supposed to solder these to the daughter board, I just don't want to make an extremely difficult to undo mistake.
Circled in red here:
Thanks for your time,
-Rob
Replies to This Discussion
-
Permalink Reply by Paul Feely on -
Rob, On my (factory soldered board) they have a small blob of solder on them holding the daughterboard permanently in place. I think they are there as locating pins and but also seem to be GND and V+ so I would solder them in.
Paul
-
Permalink Reply by Robert Sinclair on -
great thanks Paul!
-
Permalink Reply by Wesley Chuen on -
I just bend them all outward so that I could remove it easily.
Social Networking
Top Content
Contests
Season Two of the Trust Time Trial (T3) Contest has now begun. The fourth round is an accuracy round for multicopters, which requires contestants to fly a cube. The deadline is April 14th.A list of all T3 contests is here.
Groups
-
ArduRover User Group
183 members
-
Moderators
24 members
-
Telemetry over cellular …
246 members
-
ArduCopter User Group
1277 members
-
ArduCopter (traditional …
179 members
Advertisement
© 2013 Created by Chris Anderson.
Powered by
