Replies to This Discussion

Permalink Reply by Sebastian Gralla on October 27, 2010 at 7:18am

shouldn't be a problem
you have to read in the commands over serial (modify the code)
you still need an ground sided PC or Arduino (or another controller)

• ▶ Reply

Permalink Reply by Toh Yue Khing on October 27, 2010 at 10:00am

Hi I have tried, but for some unknown reason after running @115200 bps for some time, the zigbee module will hang and stop transmitting from APM , setting to 57600 bps have no issue. Hope this helps .

• ▶ Reply

ModeratorPermalink Reply by John Church on October 27, 2010 at 11:00am

Just some more info:
http://forum.sparkfun.com/viewtopic.php?f=13&t=18398

• ▶ Reply

Permalink Reply by McKinnley Workman on May 13, 2011 at 6:54am

I am working on building the arducopter and have to be able to send wireless commands from my laptop to it (like fly to a GPS coordinate-->hover for 30 sec's-->land for 10secs-->fly home-->etc). Eventually I want to be able to send it on these "missions" from an android app. I have not had experience integrating wishields and found these instructions: http://aeroquad.com/showthread.php?82-Wireless-Communication&hi... but they are for aeroquad. Would they be the same for the arducopter? How would it be different? Any resources greatly appreciated.

McKinnley

• ▶ Reply

Permalink Reply by Sebastian Gralla on May 13, 2011 at 2:07pm

you can do this with arducopter 2.x without any software changes

• ▶ Reply

Permalink Reply by Javier Rodriguez J yesterday

Hi Carlos,

Did you  find out any instructions to do it?

• ▶ Reply