Replies to This Discussion

Permalink Reply by Ritchie on June 21, 2011 at 5:07am

They use JST leads which have 3 lines. Vcc, Gnd and Analogue.

Obviously the Vcc goes to your 5V rail, Gnd goes to the ground rail and the Analogue goes to analogue points on the APM/IMU. If you look at the APM/IMU board two analogue point have all three connections next to one another.

• ▶ Reply

Permalink Reply by Jerome Lacap on June 21, 2011 at 1:37pm

Thank you Ritchie. I will try to locate these terminals.

• ▶ Reply

Permalink Reply by Jerome Lacap on July 11, 2011 at 3:16pm

DO I use the four vacant inputs to connect the four sensors? I hope somebody who had successfully installed these sensors will share the detailed steps. Thanks

• ▶ Reply