Camera parameters not available? [ac 3.0.39]

I'm looking for a stable software with acces to all Camera parameters (end-point, neutral position, angular speed, reverse) in APM Planner. Which AC software version could you recommend? Currently I use software ver.2.0.39 and there are some parameters: RC_CP_xx RC_CR_xx . Seems to be the CameraPitch and Camera Roll params. But nothing changes after few setup and servos behave exactly the same. Do I need to change something else on the parameters list?

Thanks! Mark

0 members like this

▶ Reply to This

Replies to This Discussion

Permalink Reply by Matt Gaige on November 2, 2011 at 11:01am

Why are you on 39? 49 has working parameters.

▶ Reply

Permalink Reply by maroFX on November 2, 2011 at 1:38pm

I have read somewhere an info that camera params wont be direct available any more and the only one way is to change the source code. But it's a good news - I'll try the 49

▶ Reply

RSS

Welcome to
DIY Drones

Sign Up
or Sign In

Or sign in with:

Social Networking

Top Content

1	Mapping Mission Ride Along
2	APM 2.5 from hobbyking
3	Alt_hold and loiter acting crazy
4	Looking for best laptop screen to see in the sun
5	ArduPlane 2.73 released
6	Mechanical Hands From A MakerBot: The Magic Of Robohand (From Makerbot blog news)
7	3 axis Camera Gimble connections.
8	New micro-cameras emulate insects' compound eyes
9	APM Copter 2.9.1.b has been released
10	Thirty Days (#17): 12-rotor close up

RSS
View All

Contests

Season Two of the Trust Time Trial (T3) Contest has now begun. The fourth round is an accuracy round for multicopters, which requires contestants to fly a cube. The deadline is April 14th.

A list of all T3 contests is here.