Camera parameters not available? [ac 3.0.39]

I'm looking for a stable software with acces to all Camera parameters (end-point, neutral position, angular speed, reverse) in APM Planner. Which AC software version could you recommend? Currently I use software ver.2.0.39 and there are some parameters: RC_CP_xx RC_CR_xx . Seems to be the CameraPitch and Camera Roll params. But nothing changes after few setup and servos behave exactly the same. Do I need to change something else on the parameters list?

Thanks! Mark

0 members like this

▶ Reply to This

Replies to This Discussion

Permalink Reply by Matt Gaige on November 2, 2011 at 11:01am

Why are you on 39? 49 has working parameters.

▶ Reply

Permalink Reply by maroFX on November 2, 2011 at 1:38pm

I have read somewhere an info that camera params wont be direct available any more and the only one way is to change the source code. But it's a good news - I'll try the 49

▶ Reply

RSS

Welcome to
DIY Drones

Sign Up
or Sign In

Or sign in with:

Social Networking

Top Content

1	APM Project vs DJI NAZA and WOOKONG
2	APM 2.5 with NEO-6M ublox gps (not 3DR LEA-6)
3	APM Copter 2.9.1.b has been released
4	Flying 3D Spline Curves between Waypoints with ArduCopter 3.0
5	ArduCopter-3.0 ready for wider use
6	10k autonomous flight - telemetry guided flight, and other APM tests!
7	Drone shot down by police
8	MAAT final version is being tested
9	Help Tuning Arduplane 2.73 With A Large Slow Airframe
10	Thirty Days (#28): McMaster-116 lift

RSS
View All

Contests

Season Two of the Trust Time Trial (T3) Contest has now begun. The fourth round is an accuracy round for multicopters, which requires contestants to fly a cube. The deadline is April 14th.

A list of all T3 contests is here.