CH6_RATE_KP tuning not working
Hi everyone,
I've been trying to use the CH6 tuning option with no luck. I've set the CH6 option to CH6_RATE_KP and set the min and max values to 0.10 & 0.14 respectively before clicking Write Params.
The result is that I either get 0.1 or 0.14 but nothing in between. Verifying this in the terminal window under tune, confirms that these are the only two values being recorded.
I've used the CH6 option to control my nacelle with no problems, so I'm not sure why it wouldn't work.
I'm using MP version 1.1.96 and arducopter 2.6
Thanks for any suggestions
Replies to This Discussion
-
Permalink Reply by Steven Tisseyre on -
Hi Rigel,
Did you get an answer to this?
I'm trying to do the same on my Futaba using one of the dials and if i set the min to 0.004 and the Max to 0.010 for example, a single click to the left or right of the dials takes it to the min or max values. There seems to be no scaling on the dial.
Many thanks,
Steve
-
Permalink Reply by Steven Tisseyre on
-
All solved, operator error !! CH 6 was not calibrated properly.
The range is now spot on :-)
Social Networking
Top Content
Contests
Season Two of the Trust Time Trial (T3) Contest has now begun. The fourth round is an accuracy round for multicopters, which requires contestants to fly a cube. The deadline is April 14th.A list of all T3 contests is here.
Groups
-
ArduRover User Group
183 members
-
ArduCopter User Group
1278 members
-
Andropilot Users Group
182 members
-
Moderators
24 members
-
Documentation Editors
51 members
Advertisement
© 2013 Created by Chris Anderson.
Powered by
