crc fail with XBee
Dear all,
Wen I use the USB cable I can communicate with my hexa: no problem
When I use the XBee I have problems:
- The user interface react very slow
- the terminal shows crc fail: "NavLink Bad Paket (Crc Fail)" very often: several times a second.
I use 2.0.40 software
XBee pro 50mW
Sparkfun USB Adapter on Notebook side
57600 speed.
What can i do? What I have done wrong?
thank you!
Replies to This Discussion
-
AdminPermalink Reply by Thomas J Coyle III on -
Franz,
Depending on the age of your SF USB Adapter, it may not have a voltage regulator that has sufficient current capacity to handle a Xbee Pro. The early SF USB Adapters would cause drop outs when used with a Xbee Pro. Do you have anyother USB adapters with regulators that can handle the current of the Xbee Pro to see if that is your problem? Take a look at these comments at SF concerning the USB adapter: http://www.sparkfun.com/products/8687
Just a thought.
Regards,
TCIII
Social Networking
Top Content
Contests
Season Two of the Trust Time Trial (T3) Contest has now begun. The fourth round is an accuracy round for multicopters, which requires contestants to fly a cube. The deadline is April 14th.A list of all T3 contests is here.
Groups
-
Model making for FlightG…
16 members
-
Andropilot Users Group
182 members
-
ArduCopter Italian Group
86 members
-
Documentation Editors
51 members
-
ArduPlane User Group
671 members
Advertisement
© 2013 Created by Chris Anderson.
Powered by
