Default Param File

I loaded a bad parameter file into my apm2. I cannot figure out how to restore it to default.

I have a senior telemaster using the ap to help train students (seniors at that). If anyone has a good parameter file for this 8 foot trainer I would appreciate any help.

Views: 85

▶ Reply to This

Replies to This Discussion


DeveloperPermalink Reply by Michael Oborne on June 5, 2012 at 9:38pm

enter terminal mode.

and goto setup > reset

Permalink Reply by Tom Pa on June 6, 2012 at 11:27am

Thanks again!

RSS

Social Networking

Top Content 

1 ArduPlane 2.73 released

ArduPlane 2.73 released
2 ArduVTOL

ArduVTOL
3 How to analyze a crash?

How to analyze a crash?
4 HD video for UAV's

HD video for UAV's
5 APM Copter 2.9.1.b has been released

APM Copter 2.9.1.b has been released
6 Arducopter 3Dr or Phantom

Arducopter 3Dr or Phantom
7 ArduVTOL - Wingcopter - Flight Report Nr.1

ArduVTOL - Wingcopter - Flight Report Nr.1
8 Mechanical Hands From A MakerBot: The Magic Of Robohand (From Makerbot blog news)

Mechanical Hands From A MakerBot: The Magic Of Robohand (From Makerbot blog news)
9 Mapping Mission Ride Along

Mapping Mission Ride Along
10 NEVER connect a Capacitor backup or voltage protector on APM board

NEVER connect a Capacitor backup or voltage protector on APM board

Contests

Season Two of the Trust Time Trial (T3) Contest has now begun. The fourth round is an accuracy round for multicopters, which requires contestants to fly a cube. The deadline is April 14th.

A list of all T3 contests is here. 

Groups

Advertisement

© 2013   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service