Replies to This Discussion

Permalink Reply by Charles Wolfsandle on November 8, 2011 at 12:07pm

I placed mine in this thing, but it requires a 3D printer. :)

• ▶ Reply

Permalink Reply by Wally Hallas on November 8, 2011 at 1:30pm

Cool enclosure. I don't suppose you have a spare? :)

• ▶ Reply

DeveloperPermalink Reply by Adam Rivera on November 8, 2011 at 1:40pm

I would definitely buy one of those... no 3d printer :-(

• ▶ Reply

DeveloperPermalink Reply by R_Lefebvre on November 22, 2011 at 11:47am

Yep, I found a nice little enclosure at Radio Shack/Circuit City.  It's about twice as big as it needed to be, but that's fine. I mounted the board by drilling a hole in the side for the antenna coupling.  There is a nut and washer included to clamp it down.  I attached a USB cable which is basically permanent.  I glued it into the case, so that it doesn't strain the Xbee socket.  The wire exits a second hole.  So now I have a little black box with an antenna sticking out one end, and a USB connector coming out the other side.

• ▶ Reply