ESC callibration

Hi,

It's my first post on this forum.

I received my APM2 and my 3DR quadricopter Kit with a 3DR telemetry kit.

I have a question, it is possible to calibrate ESC without any RC GEAR ?

Tks

0 members like this

▶ Reply to This

Replies to This Discussion

Permalink Reply by Aerhead on July 18, 2012 at 8:36pm

Tks

If your asking this question you have a lot of learning to do about RC stuff. If you can get a programming card for your ESCs you will find it helpful. Throttle calibration is very simple with a RC Transmitter and receiver. You tube has videos on how to do anything to do with RC, just search for it.

Good luck.

Larry

▶ Reply

RSS

Welcome to
DIY Drones

Sign Up
or Sign In

Or sign in with:

Social Networking

Top Content

1	APM 2.5 with NEO-6M ublox gps (not 3DR LEA-6)
2	APM Copter 2.9.1.b has been released
3	APM Project vs DJI NAZA and WOOKONG
4	Flying 3D Spline Curves between Waypoints with ArduCopter 3.0
5	Misadventures in power electronics
6	Drone shot down by police
7	MAAT final version is being tested
8	10k autonomous flight - telemetry guided flight, and other APM tests!
9	ArduPlane 2.73 released
10	Help Tuning Arduplane 2.73 With A Large Slow Airframe

RSS
View All

Contests

Season Two of the Trust Time Trial (T3) Contest has now begun. The fourth round is an accuracy round for multicopters, which requires contestants to fly a cube. The deadline is April 14th.

A list of all T3 contests is here.