Replies to This Discussion

Permalink Reply by Taylor Cox on April 28, 2010 at 7:47pm

Oh. I just did this yesterday. Two switch the other percentage value you have to flip the toggle switch on the top left side of the radio. There is two toggle switches on the top left, but you flip the one closest to you.

Let me know if you need more explanation.

• ▶ Reply

Permalink Reply by Jay Sherwood on April 28, 2010 at 7:54pm

Taylor - it worked! thanks so much. It's probably in the Futaba manual somewhere, but i couldn't find it. By the way, I know you responded to a few of my posts yesterday about not getting the throttle to work through the ArduPilot. To see if I had messed up CH3 on the ardupilot board, I changed substituted CH4 for CH3 in the code, re-uploaded the code and then soldered on connections to CH4 and used that for the throttle. It worked...so i must have somehow screwed up CH3 on the board. Thanks again for the input on this subject. Jay

• ▶ Reply

Permalink Reply by Taylor Cox on April 28, 2010 at 7:58pm

Not a problem. Even though I am only 19 and fairly new to this whole UAV and RC scene, I still have my fair share of good input :). This site is awesome. I'll add you as a friend as well.

• ▶ Reply

Permalink Reply by Bradley J Carr on March 29, 2012 at 12:58pm

I am not sure who will see this.  But if I have this set up and think its ready to go how can I test it on the ground to make sure that when I shut the radio off I see the inputs change and the APM react to it.

• ▶ Reply

Permalink Reply by Jeremy Zawodny on March 10, 2013 at 10:48pm

I have been trying to figure that out too...

• ▶ Reply

3D RoboticsPermalink Reply by Joshua Ott on March 10, 2013 at 11:56pm

Jeremy,

http://copter.ardupilot.com/wiki/arducopter/arducopter-setup/config...

This page is still under construction, but your question is covered there, I think :-) 

• ▶ Reply