Fun Jet from Multiplex

Hello

i will build the ardupilot on a fun jet from multiplex

my question is work it on this airframe

thank you for help

i hope you can understand my because i can not so good english

Ludwig Färber

0 members like this

▶ Reply to This

Replies to This Discussion

ModeratorPermalink Reply by Sgt Ric on July 8, 2009 at 3:18pm

Haven't you noticed the FunJet on the first page?

▶ Reply

Permalink Reply by Ludwig Färber on July 9, 2009 at 1:32am

but I've seen him but I wanted to

prefer to ask again

there is an extra software for

▶ Reply

Permalink Reply by Nick Sargeant on July 10, 2009 at 4:57am

I don't believe the Funjet it is currently supported.
Jordi was working on the code to configure the ardupilot for the funjet but i don't think he ever got to the stage of flight testing and I believe it has fallen off his list of priorities.
Hope this helps,
Nick

▶ Reply

RSS

Welcome to
DIY Drones

Sign Up
or Sign In

Or sign in with:

Social Networking

Top Content

1	APM 2.5 with NEO-6M ublox gps (not 3DR LEA-6)
2	APM Copter 2.9.1.b has been released
3	APM Project vs DJI NAZA and WOOKONG
4	Flying 3D Spline Curves between Waypoints with ArduCopter 3.0
5	Misadventures in power electronics
6	MAAT final version is being tested
7	10k autonomous flight - telemetry guided flight, and other APM tests!
8	Drone shot down by police
9	Help Tuning Arduplane 2.73 With A Large Slow Airframe
10	"Distributed Flight Array"

RSS
View All

Contests

Season Two of the Trust Time Trial (T3) Contest has now begun. The fourth round is an accuracy round for multicopters, which requires contestants to fly a cube. The deadline is April 14th.

A list of all T3 contests is here.