Replies to This Discussion

DistributorPermalink Reply by Martint BuildYourOwnDrone.co.uk on October 24, 2011 at 12:09am

Hello Teemu,

 

The PDB which is made for the quads will work with the 30 AMP ESC's the tracks are very thin and are about 5-10 mm wide in different places around the board.

You lay a small amount of solder over the tracks to thicken them (.8 - 1mm thick) to take more load, if you look at this page in the Wiki you will see a clear picture of the tracks and instructions.

A copper track laid down at the same width of around 5-10 mm with a thickness of 1mm will be more than enough to carry the power without issue and be ridged to work with :)

 

Regards

 

Martin

 

www.buildyourowndrone.co.uk

• ▶ Reply