Is my MinimOSD toast?

I can't get it to give me a signal. Configtool says can't talk to bootloader. I tried to use an ISP to reload the bootloader, but AVR studio can't communicate with it either. Could it be fried? Any check I can do to see if it's still alive?

0 members like this

▶ Reply to This

Replies to This Discussion

Permalink Reply by Andke on October 12, 2012 at 12:10am

it may seem so.

What do you think of mine, can it be that it is fried too ?

▶ Reply

Permalink Reply by Jason McPhee on October 12, 2012 at 1:13pm

Ha, that's good. How did that happen?

▶ Reply

Permalink Reply by Andke on October 12, 2012 at 2:31pm

long story short: landed in sea, salt water splashed on switch mode 5V regulator, that apparently went bananas and delivered ~16volts .. to everything.

▶ Reply

RSS

Welcome to
DIY Drones

Sign Up
or Sign In

Or sign in with:

Social Networking

Top Content

1	APM 2.5 from hobbyking
2	Alt_hold and loiter acting crazy
3	Mapping Mission Ride Along
4	Looking for best laptop screen to see in the sun
5	APM Copter 2.9.1.b has been released
6	ArduPlane 2.73 released
7	New micro-cameras emulate insects' compound eyes
8	Hobby King Ardupilot
9	3 axis Camera Gimble connections.
10	Thirty Days (#17): 12-rotor close up

RSS
View All

Contests

Season Two of the Trust Time Trial (T3) Contest has now begun. The fourth round is an accuracy round for multicopters, which requires contestants to fly a cube. The deadline is April 14th.

A list of all T3 contests is here.