Replies to This Discussion

Permalink Reply by Russell B. Sutton on May 9, 2011 at 2:27am

  So it's not just me,  I have the same troubles,  It won't load via ArduinoIDE or missionPlanner.  I tried finding what was wrong but haven't found it yet.  I let Jason know.

 

• ▶ Reply

Permalink Reply by Matthew Gray on May 9, 2011 at 3:32am

I can't get it to work either. Initially The code appeared to load and I had some cli function, but I could never make it totally through the setup.  I tried to relay the code and now nothing works.

• ▶ Reply

Permalink Reply by Ritchie on May 9, 2011 at 4:04am

Standard fault finding procedure then please.

APM version

IMU version

Attached parts (xbee magneto, etc)

I would say firmware version but thats pretty obvious :D

 

Last but not least you did sure you put the sketchbook to the inside of them ACM folder, right? (So ACM folder and libraries folder are the only visible things in the sketchbook menu).

• ▶ Reply

Permalink Reply by Matthew Gray on May 9, 2011 at 5:02am

Why would u have to do anything with the sketchbook? I have no idea what your talking about.

• ▶ Reply

Permalink Reply by LAIC on May 9, 2011 at 4:37am

same problem : loading the 1280 code via MiPl seems to work, but i never get contact via serial port afterwards.

• ▶ Reply

DeveloperPermalink Reply by Michael Oborne on May 9, 2011 at 4:53am

This problem is now fixed, please try again. there was an issue with the roms uploaded by apm planner.

• ▶ Reply

Permalink Reply by Willems Helmut on May 9, 2011 at 5:06am

are this with the xbee patch ???

• ▶ Reply

DeveloperPermalink Reply by Michael Oborne on May 9, 2011 at 5:21am

not that i am aware of at this stage

• ▶ Reply

Permalink Reply by Willems Helmut on May 9, 2011 at 5:24am

because in other thread they told to add 3 lines to apmconfig , if i do and compile i get compille error also when i don't add i get compile error

• ▶ Reply

Permalink Reply by stonk101 on May 9, 2011 at 4:54am

Same issue, download (missionPlanner) looks to have worked, but no comm's opening terminal gives a "opened com port" then hangs.

No attached parts
using 1280 code.

update:
OK, reload mission planner everything now works. ( The interface is very clean).

• ▶ Reply

Permalink Reply by LAIC on May 9, 2011 at 5:34am

suuuuuuuuuper

 

thanks to the fast team ! 

- i'm impressed

• ▶ Reply

Permalink Reply by Nigel on May 9, 2011 at 5:27am

Ok, many thanks, this problem seems to have been fixed.  I have successfully downloaded the latest version and it connects to the Mission Planner terminal properly.

 

Many thanks!

• ▶ Reply