Replies to This Discussion

Permalink Reply by wraith on January 28, 2012 at 12:13am

hi, im thinking of getting 1 of these osd's, what info is it displaying on the screen?, is it easy to setup?, any programming requied to set it up?

• ▶ Reply

Permalink Reply by Andre Lochner on January 28, 2012 at 12:59am

Also experienced the same problem.

• ▶ Reply

Permalink Reply by Eoin on January 28, 2012 at 10:00am

@glen: In regard to what information it displays on screen, this post MinimOSD in DIYDrones Store! gives a full list.

Setup was very easy. I use the 5v output from my transmitter to power both the camera and one stage of the OSD. The other stage is fed by the APM. There is no programming required to set it up. It is pre-flashed with the firmware.

I believe a configurator is being developed (Anyone have word on this ?)  Hopefully it will allow a lot more customising.   

• ▶ Reply

Permalink Reply by gustavo on March 16, 2013 at 8:43am

Hi Eoin, i have  connected my minimosd with a video cammera , and worked perfect.

then i added a fatshark , Tx works fine, but minimosd second stage seams to be burned, i had separated the analog and digital power supplies,  you mentioned to be using the fat shark power supply  to the minimosd second stage, FS  has a +5 v, out , and minimosd says +7v to 18 volts ,

does it really works well with +5 ?

 

thanks

 

• ▶ Reply