Minim Osd Blackscreen

I just received my MinimOsd and I have a pal camera. I soldered all the pins and jumper pads to have the APM 5v provide power to the whole board and the camera and transmitter with their own power and ground. When I have the 5v only plugged in the whole board lighted up but the chip on the APM side gets pretty hot.(is this normal) I also soldered the pal pad on the board. All soldered points are clean and perfect not sloppy. The video feed just shows a black screen and no data is showing on the screen. I unplug the power to the camera and it goes fuzzy. I have the video in the corrected input and outputs. I am at a loss what do I need to do to get this working.

It working in a since but just no image or OSD information. Is my board bad?

0 members like this

▶ Reply to This

Replies to This Discussion

Permalink Reply by dudz on May 7, 2012 at 4:22am

Hi ZacCom, did you ever sort this out ?

▶ Reply

RSS

Welcome to
DIY Drones

Sign Up
or Sign In

Or sign in with:

Social Networking

Top Content

1	APM Project vs DJI NAZA and WOOKONG
2	APM 2.5 with NEO-6M ublox gps (not 3DR LEA-6)
3	APM Copter 2.9.1.b has been released
4	Flying 3D Spline Curves between Waypoints with ArduCopter 3.0
5	ArduCopter-3.0 ready for wider use
6	10k autonomous flight - telemetry guided flight, and other APM tests!
7	Drone shot down by police
8	MAAT final version is being tested
9	Help Tuning Arduplane 2.73 With A Large Slow Airframe
10	Thirty Days (#28): McMaster-116 lift

RSS
View All

Contests

Season Two of the Trust Time Trial (T3) Contest has now begun. The fourth round is an accuracy round for multicopters, which requires contestants to fly a cube. The deadline is April 14th.

A list of all T3 contests is here.