Replies to This Discussion

3D RoboticsPermalink Reply by Chris Anderson on July 16, 2011 at 9:04pm

Update your Mission Planner to the latest version. 1.0.36

• ▶ Reply

3D RoboticsPermalink Reply by Joshua Ott on July 16, 2011 at 9:39pm

Same problem here. I first updated Mission Planner and it now shows version 1.0.36 in it's start up screen. I started the AC2 firmware update and get to the very end and receive the message -update successful verify failed, and was not able to clear that dialog pop up, had to restart my computer. I repeated this entire process three times with the same results each time. I went ahead and did the initial setup and then a very short hover only test flight with no problems however.

• ▶ Reply

Permalink Reply by Naji Karim on July 16, 2011 at 9:47pm

Same issue with the APM Planner 1.36 and the Failed to Verify Issue. I used Arduino to upload and used APM 1.36 to configure. Flew the quad and all seemed normal.

I just tried to check the logs, but was not able to see any. If you disconnect the battery, do you lose your logs?

• ▶ Reply

3D RoboticsPermalink Reply by Chris Anderson on July 16, 2011 at 10:02pm

It looks like the latest code only works on the APM2560 boards. We're going to try to nurse along the APM1280s as long as we can, so we'll see if we can get find some memory savings and get them back up to date with the latest code, but pretty soon we're going to have to draw the line.

• ▶ Reply

3D RoboticsPermalink Reply by Joshua Ott on July 16, 2011 at 10:08pm

roger that, I've got 1280s, so that is the problem. Thanks, I'll bite the bullet and buy some new boards. Is ardupilot advancing past the 1280 also, or just AC2?

• ▶ Reply

3D RoboticsPermalink Reply by Chris Anderson on July 16, 2011 at 10:28pm

Yes, APM is close to the end of 1280 support, too.

• ▶ Reply

3D RoboticsPermalink Reply by Joshua Ott on July 16, 2011 at 10:33pm

alright time to spend a little more money at my favorite store : ) I need new magnetometers anyway, if I'm paying for shipping I might as well throw a couple more items in the box.

• ▶ Reply

ModeratorPermalink Reply by Hai Tran on July 16, 2011 at 10:39pm

I'm finding that 2.0.33 seems the best for my Hexa right now.  Updated to 2.0.36, then down to 2.0.34, the down again to 2.0.33.

 

I think my APM 2560 has arrived an is waiting for me at my office.

• ▶ Reply

DistributorPermalink Reply by Martint BuildYourOwnDrone.co.uk on July 17, 2011 at 12:53am

A few people have been talking about this issue over in this thread:

 

http://diydrones.com/forum/topics/upload-succeeded-but-verify?xg_so...

 

Looks very much like Michael is going to take a look!

 

Regards

 

Martin

 

• ▶ Reply