My Bixler 1.1 Drone Project

Hi all,

I newly developed a fixed wing drone with Bixler 1.1 from hk.

Below picture is autopilot cockpit module I designed for pixhawk.

I had to extend front section of the cockpit from its original length to fit longer pixhawk into the cockpit.

Also note the GPS mount and pitot tube mount.

3691328800?profile=original

You can see the difference between the original cockpit and 3d printed cockpit.3691328842?profile=original

When finished, all the components are nicely attached to the cockpit as shown below.

3691329017?profile=original

3691328986?profile=original

Most of the components are mounted inside the cockpit and I hope this may help reducing the drag if mounted externally.

Hope I can report some good news later.

Thanks,

Kyu 

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

  • Thanks for your comment.

    Unfortunately, I don't have pixracer now but will look at it. 


    Johnatan said:

    Nice build. Have you seen the Pixracer? It is much more smaller than the Pixhawk 1 and has better sensors.

  • Nice build. Have you seen the Pixracer? It is much more smaller than the Pixhawk 1 and has better sensors.

This reply was deleted.

Activity