Hello,

So I am stumped on how to bring the openpilot board together with the DIY drones power dist. board.

The power dist. board has the 4 sets of the 3 prong connections for the esc's. But the openpilot has them as well. Can anyone explain to me what I need to do next?

I feel I have everything in rout or in my possession to get my quad in the air. I just need some advice on how to bring it all together.

So far what I have in hand

1-VC-450 quad frame

1-DIY drones power dist. board

1-open Pilot CC board

1-Spektrum DX6i also the AR6210 6-ch DSMX receiver

2-10"x4.5 prop sets w/ adapters

In rout...

4-NTM Prop Drive series 28-26A 1200kv /250w

4-Turnigy Plush 30amp speed controls

2-Turnigy 3000mAh 3S 20c Lipo's

 

any help/ direction would be much appreciated

Views: 376

Reply to This

Replies to This Discussion

did you work this out? still need help?

I am pretty sure that the 3 conductor for ESC are simple pass through points, it is very strait forward. You should ask in the OpenPilot forums!

Franco

 

RSS

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Drone Delivery Challenge, is here

© 2014   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service