optical flow sensor

I have a hexacopter APM2. I have placed on an optical sensor.
Up and a red LED is on and there was nothing else he was doing. Can someone help?
The parameters I have enabled (FLOW_ENABLE 1)

Joe

0 members like this

▶ Reply to This

Welcome to
DIY Drones

Sign Up
or Sign In

Or sign in with:

Social Networking

Top Content

1	APM 2.5 with NEO-6M ublox gps (not 3DR LEA-6)
2	APM Copter 2.9.1.b has been released
3	APM Project vs DJI NAZA and WOOKONG
4	Flying 3D Spline Curves between Waypoints with ArduCopter 3.0
5	Misadventures in power electronics
6	Drone shot down by police
7	MAAT final version is being tested
8	10k autonomous flight - telemetry guided flight, and other APM tests!
9	ArduPlane 2.73 released
10	Help Tuning Arduplane 2.73 With A Large Slow Airframe

RSS
View All

Contests

Season Two of the Trust Time Trial (T3) Contest has now begun. The fourth round is an accuracy round for multicopters, which requires contestants to fly a cube. The deadline is April 14th.

A list of all T3 contests is here.