So i was updating my PixHawk the other day and there was a blip in the power that caused the computer to reboot right in the middle of a flash. The pixhawk will connect to mission planner but the only option is flash firmware and in the mission planner main screen nothing is working and no data is showing up. When trying to re-flash the Arducopter or arduplane firmware it hangs everytime and never completes the flash.
Is this thing smoked or is there any way to bring it back from the dead?
Replies
Try booting with the safety switch held down.
I have attempted that though i don't know if there is a correct sequence that initiates a "re-boot". I know with my router you must press it and hold it down while powering it and keep it depressed for a certain number of seconds. is there a process such as this with the Pixhawk?