Power Supply?

Hey,

I was just wondering what level of maH I am going to need my LiPO to be at in order to power the FMA Co-Pilot, 4 servos, Ardupilot, motor and GPS for about 30 mins? will 3200maH, 11.1V do me?

Thanks a lot,

James

Views: 13

▶ Reply to This

Replies to This Discussion


3D RoboticsPermalink Reply by Chris Anderson on April 12, 2009 at 8:53pm
Totally depends on your motor. The autopilot and attached electronics are a trivial drain compared to your that. You should check out other forums, such as RCGroups, for info on brushless motor power ratings, etc.
Permalink Reply by James on April 12, 2009 at 9:07pm
Thanks Chris will do,

James

RSS

Social Networking

Top Content 

1 Mapping Mission Ride Along

Mapping Mission Ride Along
2 Alt_hold and loiter acting crazy

Alt_hold and loiter acting crazy
3 ArduPlane 2.73 released

ArduPlane 2.73 released
4 APM 2.5 from hobbyking

APM 2.5 from hobbyking
5 ArduVTOL - Wingcopter - Flight Report Nr.1

ArduVTOL - Wingcopter - Flight Report Nr.1
6 Mechanical Hands From A MakerBot: The Magic Of Robohand (From Makerbot blog news)

Mechanical Hands From A MakerBot: The Magic Of Robohand (From Makerbot blog news)
7 3 axis Camera Gimble connections.

3 axis Camera Gimble connections.
8 Looking for best laptop screen to see in the sun

Looking for best laptop screen to see in the sun
9 New micro-cameras emulate insects' compound eyes

New micro-cameras emulate insects' compound eyes
10 Thirty Days (#13): Y6 in-flight motor failure tests

Thirty Days (#13): Y6 in-flight motor failure tests

Contests

Season Two of the Trust Time Trial (T3) Contest has now begun. The fourth round is an accuracy round for multicopters, which requires contestants to fly a cube. The deadline is April 14th.

A list of all T3 contests is here. 

Groups

Advertisement

© 2013   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service