Hey,

I was just wondering what level of maH I am going to need my LiPO to be at in order to power the FMA Co-Pilot, 4 servos, Ardupilot, motor and GPS for about 30 mins? will 3200maH, 11.1V do me?

Thanks a lot,

James

Views: 44

Reply to This

Replies to This Discussion

Totally depends on your motor. The autopilot and attached electronics are a trivial drain compared to your that. You should check out other forums, such as RCGroups, for info on brushless motor power ratings, etc.
Thanks Chris will do,

James

RSS

DIY Drones Monthly
Newsletter

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2016   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service