I have an APM 1280 board, uploaded Arduplane v2.33. Since the upload an after radio setup I cannot get the APM to recognize any TX inputs. It will only recognize inputs when connected to my computer via USB but not when in normal setup. the ppm light remains solid blue. What am i doing wrong?

Views: 176

Reply to This

Replies to This Discussion

Petrus, you might have a wiring problem :-)

Switch in the correct position?

thanks gustav, I think I found the problem, my speed controller output. will let you know

Reply to Discussion


DIY Drones Monthly


Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2016   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service