Predator UAV

Hi

I have one question.

If i going to adapt the ardupilot to the predator, then i must change the code and add v-tail stuff ?

But if i use a v-tail mixer? then i must tweak the pid gains and change the code less?

What do you guys think?

Tags: predator, uav, v-tail

0 members like this

▶ Reply to This

Replies to This Discussion

Permalink Reply by DougB on August 1, 2009 at 7:21am

I'm using a V-Tail mixer on my predator and should begain doing flight testing next week. I'll post my setting as it comes along.

Doug

▶ Reply

Permalink Reply by NorthSweden on August 1, 2009 at 10:17am

Sounds good,

Hope it will turn out good,

I will order a v-tail mixer right now.

▶ Reply

Permalink Reply by Connor on September 25, 2009 at 12:01pm

Hello I am trying to do the same thing as you and was wondering if you had made any progress

▶ Reply

Permalink Reply by NorthSweden on September 25, 2009 at 1:01pm

Hi

I have the project on ice right now and have not tested any more.

may be Doug have some progress?

▶ Reply

RSS

Welcome to
DIY Drones

Sign Up
or Sign In

Or sign in with:

Social Networking

Top Content

1	APM Project vs DJI NAZA and WOOKONG
2	APM 2.5 with NEO-6M ublox gps (not 3DR LEA-6)
3	APM Copter 2.9.1.b has been released
4	Flying 3D Spline Curves between Waypoints with ArduCopter 3.0
5	ArduCopter-3.0 ready for wider use
6	10k autonomous flight - telemetry guided flight, and other APM tests!
7	Drone shot down by police
8	MAAT final version is being tested
9	Getting ready for Arducopter 3.0
10	Help Tuning Arduplane 2.73 With A Large Slow Airframe

RSS
View All

Contests

Season Two of the Trust Time Trial (T3) Contest has now begun. The fourth round is an accuracy round for multicopters, which requires contestants to fly a cube. The deadline is April 14th.

A list of all T3 contests is here.