Hello.

I have recently purchased a new ardupilot mea board. Having soldered and connected it to the shield, I attempted to upload the firmware. However, I get the following error:

Failed to read firmware.hex: Index was outside the bounds of the array.

Any help on the issue would be greatly appreciated.

Regards,

Charles

Views: 95

Reply to This

Replies to This Discussion

I assume you're loading from the Mission Planner. Did it download the firmware from the Internet correctly, and then start the upload to your board?

RSS

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Drone Delivery Challenge, is here

© 2014   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service