Programming more modes

I've been flying with a Spektrum DX5e until now, so I was only able to use the "gear" selection (5th channel) to switch between auto and manual.

 

My new DX7 allows me 2 more channels theoretically, but I'm stumped as to how to implement it for changing to other modes??

 

On the manual, the diagram indicates pin 8 (in, autopilot control) on the APM should connect to the receiver. This is fine for one mode. But now how can I get my receiver's extra channels to tell the APM to go to RTL, FBW etc?

 

On the "modes" setup it does not see me switching the additional channels on my transmitter (DX7), only the "gear" switch is picked up by the CLI. I've tried connecting another cable from pin 7 to my receiver, but no luck.

 

Please help!?

 

Thanks

Views: 329

▶ Reply to This

Replies to This Discussion

Permalink Reply by Antonio on September 10, 2011 at 8:26am

With 4 modes i've to mix 2 channels too??

If you post it, perfect, in that way i can check what is the best choice for me..

 

Thanks again...

Permalink Reply by herve pellarin on April 22, 2012 at 1:05am

this is the result you get, thx felix

Permalink Reply by Felix Meissner on September 10, 2011 at 9:35am

yes,

using two 2 position switches (Gear and Aux) gives you 4 modes,

one 2 position (Gear or Aux) and one 3 position switch (Flaps) gives you 6 modes ...

 

Permalink Reply by Antonio on September 10, 2011 at 9:37am

Ok, Felix much more clear now.... thanks...

RSS

Social Networking

Top Content 

1 ArduPlane 2.73 released

ArduPlane 2.73 released
2 Mapping Mission Ride Along

Mapping Mission Ride Along
3 HD video for UAV's

HD video for UAV's
4 Arducopter 3Dr or Phantom

Arducopter 3Dr or Phantom
5 3 axis Camera Gimble connections.

3 axis Camera Gimble connections.
6 APM Copter 2.9.1.b has been released

APM Copter 2.9.1.b has been released
7 Mechanical Hands From A MakerBot: The Magic Of Robohand (From Makerbot blog news)

Mechanical Hands From A MakerBot: The Magic Of Robohand (From Makerbot blog news)
8 ArduVTOL - Wingcopter - Flight Report Nr.1

ArduVTOL - Wingcopter - Flight Report Nr.1
9 How to analyze a crash?

How to analyze a crash?
10 ArduVTOL

ArduVTOL

Contests

Season Two of the Trust Time Trial (T3) Contest has now begun. The fourth round is an accuracy round for multicopters, which requires contestants to fly a cube. The deadline is April 14th.

A list of all T3 contests is here. 

Groups

Advertisement

© 2013   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service