I've been flying with a Spektrum DX5e until now, so I was only able to use the "gear" selection (5th channel) to switch between auto and manual.

 

My new DX7 allows me 2 more channels theoretically, but I'm stumped as to how to implement it for changing to other modes??

 

On the manual, the diagram indicates pin 8 (in, autopilot control) on the APM should connect to the receiver. This is fine for one mode. But now how can I get my receiver's extra channels to tell the APM to go to RTL, FBW etc?

 

On the "modes" setup it does not see me switching the additional channels on my transmitter (DX7), only the "gear" switch is picked up by the CLI. I've tried connecting another cable from pin 7 to my receiver, but no luck.

 

Please help!?

 

Thanks

Views: 331

Reply to This

Replies to This Discussion

With 4 modes i've to mix 2 channels too??

If you post it, perfect, in that way i can check what is the best choice for me..

 

Thanks again...

this is the result you get, thx felix

yes,

using two 2 position switches (Gear and Aux) gives you 4 modes,

one 2 position (Gear or Aux) and one 3 position switch (Flaps) gives you 6 modes ...

 

Ok, Felix much more clear now.... thanks...

RSS

Social Networking

Contests

Season Two of the Trust Time Trial (T3) Contest has now begun. The fourth round is an accuracy round for multicopters, which requires contestants to fly a cube. The deadline is April 14th.

A list of all T3 contests is here

Advertisement

© 2013   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service