I'm not getting any logs from my PX4.  I'm running firmware 3.1.3 on Y6B and using MP 1.3.1.  I'm trying to analysis my logs but all I get is 6 lines in the log file.  (See below)  I've tried formatting my SD card, but that did not help.  Anyone have any ideas why this is happening?

Thanks,
Richard

Views: 308

Attachments:

Reply to This

Replies to This Discussion

Here is a screenshot of the log.

@Richard,

What is the value of your log bit mask parameter?

Regards,

TCIII Ardurover2 Developer

Hi Tom,

I checked my log bit mask and it was 22526.  I changed it to 958, which did not help.  I then erased and reset the PX4 and reloaded my parameters, with the log bit mask set at 958, which is default + IMU.  Still getting tiny logs with no info.  The log size is 89 bits and it's like PX4 is not writing anything.  When I first erase the logs, the default log starts at 89 bits.  Wonder if I should reach out to 3DR support?

Thanks,

Richard

@Richard,

Try 65535.

Regards,

Tom C ArduRover2 Developer

Reply to Discussion

RSS

© 2018   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service