Discussions

PX4/QGC: "Vehicle did not respond to command: calibration"

Posted by Esteban Roitberg on February 16, 2017 at 10:09am

Hi! I'm new to DIYDRONES, sorry if this is not the right place to ask this.

I have quadcopter with a pixhawk and PX4. I use it with QGroundControl. Sometimes the message "Vehicle did not respond to command: calibration" appears. Does anybody know why?

The quadcopter is working fine, so this is just to satisfy my curiosity.

Thanks!

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • Esteban Roitberg March 5, 2017 at 3:11pm

    Hi! Sadly, no, I didn't find out. I didn't ask anywhere else, though.

    I had to re install the firmware, so I don't have that message anymore. But if I found out, I'll tell you.

  • JimD March 5, 2017 at 1:44pm

    Esteban,

    I have the same question.

    Did you ever find out?

This reply was deleted.

Activity