Set a digital bit on APM2 or on 433mhz radio from low to high with the mission planner
Using MP terminal can I send RTS1=1 to set a bit high on the APM2 like one of the free analog ports ?
The send is to the remote 433mhz radio to set a bit somewhere to signal a FET to heat up and cut the nylon cord attached to the high altitude balloon.
Earl
Replies to This Discussion
-
Permalink Reply by Earl on -
This is what I am basing it on.
The AT commands available are:
- ATI - show radio version
- ATI2 - show board type
- ATI3 - show board frequency
- ATI4 - show board version
- ATI5 - show all user settable EEPROM parameters
- ATI6 - display TDM timing report
- ATI7 - display RSSI signal report
- ATO - exit AT command mode
- ATSn? - display radio parameter number 'n'
- ATSn=X - set radio parameter number 'n' to 'X'
- ATZ - reboot the radio
- AT&W - write current parameters to EEPROM
- AT&F - reset all parameters to factory default
- AT&T=RSSI - enable RSSI debug reporting
- AT&T=TDM - enable TDM debug reporting
- AT&T - disable debug reporting
all of these commands, except for ATO, may be used on a connected remote radio by replacing 'AT' with 'RT'.
Social Networking
Top Content
Contests
Season Two of the Trust Time Trial (T3) Contest has now begun. The fourth round is an accuracy round for multicopters, which requires contestants to fly a cube. The deadline is April 14th.A list of all T3 contests is here.
Groups
-
Documentation Editors
51 members
-
ROS User Group
75 members
-
Moderators
24 members
-
ArduRover User Group
184 members
-
ArduPlane User Group
685 members
Advertisement
© 2013 Created by Chris Anderson.
Powered by
