Just installed my new APM2 and connected everything up, everything works OK (Great product)
The compass and HUD move as I move the board but if the board is pointing north I find thecompass is reading west, remote gps connector is at the front facing north, I have set the declination anlge correct for my location but cannot find the calibrate button on the mission planner uploaded today.how do I calibrate the compass please
Check out the manual:
Thanks for the reply.
I checked the manual and in the hardware setup tab it shows a calibration button (green) . on my mission planner 1-1-48 I dont have the button,? I have no logs to enter as its new and my plane is not ready to fly.
How do I get a calibrate button?
You have an ancient version of the MP! Please upgrade to the latest version (1.1.66) here.
Thanks Chris for your support, You have a happy newbie.
Will this work on Win 7 64 bit?
yes it will
Have you noticed my comment in the Wiki below the page where I attempted to clarify the magnetic declination entry? I basically wish to clarify exactly what is meant to be entered so that ArduPlane applies the correct declination.