Sim using Flightgear only stable in Acro works

Im trying to get sim and Flight gear working, but all the settings Ive tried apart from Acro, the quad swings/yaws  from side to side constantly. 

Ive tried stabilize, stabilize simple, all the set modes with and without simple, autopilot and yet all swing side to side soon as I flick the switch.If i make any correction or pitch or roll it goes even worse.

In acro it works ok, it just seems to be in manual though with not return to level if you let the stick off to centre.

I installed the latest hil firmware , MP software and calibrated all the settings.

Ive tried altering the PIDs and have managed to reduce the yaw oscillation, but cant get rid of it all together. But what ever the case it is unflyable with this yaw oscillation.

Reading the forums it seems Im not the only one with this problem and most have the same issues, so any help would be very much appreciated by many.

Please help and advise what I am doing wrong here? Thank you in advance. John

Views: 87

▶ Reply to This

Replies to This Discussion

Permalink Reply by John Campen on January 29, 2012 at 5:42pm

Can anyone help on this please? After all the looking around and comments from others (on different post) there does seem to be a problem with HIL/FG firmware


DistributorPermalink Reply by Dany Thivierge on February 2, 2012 at 9:42pm

Same issue for me... just tried it... fresh 2.3 HIL on APM 1 (1280)  it wont stop oscillation... throttle up works, but as soon as some yaw or pitch is applied all hell breaks louse!

I tried also Aerosim but when selecting the plugin I get a version error... I guess things have changed too much and the simulator is broken... 

Jean-Louis please help! hehehe

Permalink Reply by lot on August 18, 2012 at 5:36pm

Same issue for me...

I'm using last version of Mission Planer on Parallels Desktop in Snow Leopard.

RSS

Social Networking

Top Content 

1 APM Project vs DJI NAZA and WOOKONG

APM Project vs DJI NAZA and WOOKONG
2 APM 2.5 with NEO-6M ublox gps (not 3DR LEA-6)

APM 2.5 with NEO-6M ublox gps (not 3DR LEA-6)
3 APM Copter 2.9.1.b has been released

APM Copter 2.9.1.b has been released
4 Flying 3D Spline Curves between Waypoints with ArduCopter 3.0

Flying 3D Spline Curves between Waypoints with ArduCopter 3.0
5 ArduCopter-3.0 ready for wider use

ArduCopter-3.0 ready for wider use
6 10k autonomous flight - telemetry guided flight, and other APM tests!

10k autonomous flight - telemetry guided flight, and other APM tests!
7 Drone shot down by police

Drone shot down by police
8 MAAT final version is being tested

MAAT final version is being tested
9 Help Tuning Arduplane 2.73 With A Large Slow Airframe

Help Tuning Arduplane 2.73 With A Large Slow Airframe
10 Thirty Days (#28): McMaster-116 lift

Thirty Days (#28): McMaster-116 lift

Contests

Season Two of the Trust Time Trial (T3) Contest has now begun. The fourth round is an accuracy round for multicopters, which requires contestants to fly a cube. The deadline is April 14th.

A list of all T3 contests is here. 

Groups

Advertisement

© 2013   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service