telemetry module wont enter command mode 3dr radio

Hi Guys I have a mate who has just tried seting up telemetry 3dr radios and the home base module

wont connect so we went to try and upload new firmware but it fails to enter command mode ,is there a workaround or is it fried?

cheers

Glen

0 members like this

▶ Reply to This

Replies to This Discussion

Permalink Reply by Hugues on February 5, 2013 at 2:12pm

Hello,
This is normal and documented on the wiki : no cli with radio connection. You have ro use usb cable to access cli.

▶ Reply

RSS

Welcome to
DIY Drones

Sign Up
or Sign In

Or sign in with:

Social Networking

Top Content

1	APM Project vs DJI NAZA and WOOKONG
2	ArduCopter-3.0 ready for wider use
3	Flying 3D Spline Curves between Waypoints with ArduCopter 3.0
4	APM Copter 2.9.1.b has been released
5	APM 2.5 with NEO-6M ublox gps (not 3DR LEA-6)
6	10k autonomous flight - telemetry guided flight, and other APM tests!
7	MAAT final version is being tested
8	Getting ready for Arducopter 3.0
9	Help Tuning Arduplane 2.73 With A Large Slow Airframe
10	How to succeed without really trying

RSS
View All

Contests

Season Two of the Trust Time Trial (T3) Contest has now begun. The fourth round is an accuracy round for multicopters, which requires contestants to fly a cube. The deadline is April 14th.

A list of all T3 contests is here.