Replies to This Discussion

3D RoboticsPermalink Reply by Chris Anderson on April 2, 2011 at 11:56am

Cosmetic, I think. uBlox sats # may not be passed on in telemetry stream. no worries.

• ▶ Reply

Permalink Reply by Rashed alzaabi on April 2, 2011 at 11:58am

well then why i got wrong Altitude? check the pic called Long, i was test while im driving not flying!

• ▶ Reply

Permalink Reply by Darren on April 2, 2011 at 1:09pm

Just FYI, I tested on APM 2.011 with HK GCS v1.2.48, and is # sats is working fine from my ublox.

(HDOP isnt but thats normal for now as I think its not in the mavlink stream and havnt seen that in a long time...)

I tested with both .zip format with Arduino uploader and APM Planner uploader

 

edit: I also just tested svn v2538, also with no issues on # sats from ublox

• ▶ Reply

Permalink Reply by Darren on April 2, 2011 at 12:31pm

quick question, are you using APM Planner uploader or arduino uploader?

Hit me up on the chat and i can help you diagnose your ublox

• ▶ Reply

Permalink Reply by Rashed alzaabi on April 2, 2011 at 2:11pm

i used APM Planner for my firmware

edit: i also upload the firmware without Mavlink just regular APM 2.011 FYI :)

• ▶ Reply

Permalink Reply by Rashed alzaabi on April 3, 2011 at 11:49am

so you found anything that might help me XD?

• ▶ Reply

Permalink Reply by Darren on April 5, 2011 at 6:12pm

Been out of town fishing the past few days. I have a tournament coming up. Am back now, so can help you if your still having issues.

 

Darren

 

• ▶ Reply

Permalink Reply by Rashed alzaabi on April 5, 2011 at 9:24pm

Welcome, No thank Happykillmore helped me to enable NAV_SOL was disable in u-center.

• ▶ Reply

Permalink Reply by Rebel K on April 14, 2011 at 11:30am

@ Rashed ! 

As I'm having a similar issue, could you please state how you got around this problem? What changes do I have to make? 

Thanks!

• ▶ Reply

Permalink Reply by Rashed alzaabi on April 14, 2011 at 3:09pm

in U-center make sure ""NAV_SOL" and "NAV_VELNED"" are enable 

 

i recommend you to visit this thread and check my posts with HK post starting from Post number 289

 

http://www.rcgroups.com/forums/showthread.php?t=1334171&page=20

• ▶ Reply

Permalink Reply by Rebel K on April 14, 2011 at 8:53pm

Thank you Rashed !

I'll get to it ASAP !

=)

• ▶ Reply

Permalink Reply by Paul Mather on April 15, 2011 at 7:29pm

I tried to get Rashed to get help here....but he just wouldn't listen. I tried to give up on him a few times but he just wouldn't let me. In the end, he managed to make the cable he needed and follow my directions....it all worked out in the end.

• ▶ Reply

• ‹ Previous
• 1
• 2
• Next ›
• Page