unable to reprogram ppm encoder module with avr isp

Hi

I ordered a 8 Channel PPM Encoder and now I'd like to change the software on it. I connected an AVRISP mkII In-System Programmer to the ISP Pins, but the only message I get in avr studio programmer is: 

could not enter programming mode.


I already tried to lower the frequency of the programmer. The led on the programmer turns to green which is correct. I flashed other mc's successfully with the same programmer.

Is there anything special I need to take care of?

Thanks a lot!

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

  • Its working now, the programmer was the issue.
This reply was deleted.

Activity