aispeed on a apm 2.5

I will ask the same question as someone else who never got an answer.

have i got to add pins to the apm 2.5 for a airspeed sensor or are they already taken care of in the row of pins at the top which take the airflow etc.

Thanks

0 members like this

Replies to This Discussion

Permalink Reply by Richard on January 5, 2013 at 4:59am

Terry - I don;t personally own a 2.5 board, but i believe it is very similar to the APM2 board - In the manual, on this page, the 3rd image down shows the APM pins, and what they do, Airspeed is in the corner...

Permalink Reply by Richard on January 5, 2013 at 5:00am

Permalink Reply by Terry McKinley on January 5, 2013 at 12:22pm

Thanks thats what I thought but somehow could not find this pic

Cheers

DeveloperPermalink Reply by Kevin Hester on January 5, 2013 at 9:13am

They are already there on the 2.5, just plug into the A0 position.

My airspeed sensor came missing the 3 pin header, so I did have to solder on a .1" spacing 3 pin header. No biggie.

Permalink Reply by Terry McKinley on January 5, 2013 at 12:23pm

Cheers info now complete

RSS

Welcome to
DIY Drones

Sign Up
or Sign In

Or sign in with:

Social Networking

Top Content

1	APM Project vs DJI NAZA and WOOKONG
2	APM 2.5 with NEO-6M ublox gps (not 3DR LEA-6)
3	APM Copter 2.9.1.b has been released
4	Flying 3D Spline Curves between Waypoints with ArduCopter 3.0
5	ArduCopter-3.0 ready for wider use
6	10k autonomous flight - telemetry guided flight, and other APM tests!
7	Drone shot down by police
8	MAAT final version is being tested
9	Help Tuning Arduplane 2.73 With A Large Slow Airframe
10	Thirty Days (#28): McMaster-116 lift

RSS
View All

Contests

Season Two of the Trust Time Trial (T3) Contest has now begun. The fourth round is an accuracy round for multicopters, which requires contestants to fly a cube. The deadline is April 14th.

A list of all T3 contests is here.