all 4 motors shut down for1 sec during flight. What's that?
While hovering I noticed all motors shut down few times and started again after about 1sec. I power AP board, Reciver and Roll/Pitch servos separately from different ESC BEC (with common GND only). There shouldn't appear brown outs. So what's the reason? [APM CPU 2560, soft v2.5]. Could it have something to do with bad Yaw and Throttle PID settings?
Replies to This Discussion
-
Permalink Reply by Hans C on -
Randy,
I use APM1 and no xbee.
I hope I have the correct files that shows my problem most clearly.
When using 2.5.3 no strange behaviour related to this at all.
No changes made to the hardware or crashes.
Did the erase / reset / reload / config etc. to the 2.5.4
Happened more than once.
- Attachments:
-
-
2012-05-02 20-42 42.log, 830 KB -
2012-05-02 19-22 45.log, 741 KB
-
-
-
Permalink Reply by maroFX on -
Your logs look like the motors shut down for a long time. In my case there is only a short break.
Should I try to change PPM encoder if my board is the CPU2560 version?
-
- ‹ Previous
- 1
- 2
- 3
- Next ›
Social Networking
Top Content
Contests
Season Two of the Trust Time Trial (T3) Contest has now begun. The fourth round is an accuracy round for multicopters, which requires contestants to fly a cube. The deadline is April 14th.A list of all T3 contests is here.
Groups
-
ArduCopter User Group
1288 members
-
Agricultural UAVs
125 members
-
techpod users
39 members
-
Queensland
4 members
-
Moderators
24 members
Advertisement
© 2013 Created by Chris Anderson.
Powered by
